Menu
Cart 0

eGo W Kit Manual

Posted by Barbara F on

 

Charging your EGO-W electronic starter kit

 Plug your USB charge cable that was included with your kit into an available USB slot which can be found on most electronic devices for example PC, MAC, Games console, Laptop or a wall charger. Once plugged in the LED on the charge cable will turn green, Screw your 1100mah EGO battery into the charging unit and the LED will turn red to indicate that a charge is needed, once the battery has reached full charge the LED will turn back to green to indicate that it is now fully charged and ready for use.

 

Filling & assembling your EGO-W cartomizer

 The cartomizer and cover may already be assembled if so remove the drip tip by gently pulling, remove the EGO-W cover by also gently pulling. The starter kit comes with a needle tip filling bottle which is used to fill the tank with e- juice simply fill the bottle with your flavour of choice, insert the needle tip into one of the two cut out filling holes located in the top of the tank. When filling for the first time you may have to apply extra pressure to get the needle tip through the silicone. Once through the silicone and the needle tip is visible inside the tank gently fill the tank to the desired level (can hold 2ml) then pull out your needle tip, place the cover over the cartomizer then on the open end place the rubber mouth piece on by pushing into place . You will notice the cover has slits down either side so you can effectively monitor the e-juice level which eliminates the risk of running the unit dry. You then should wait for approx 5 mins to give the juice a chance to soak into the wicking material properly or you can take a few dry puffs until you are happy that the liquid has fully soaked through. The EGO-W also comes with a pen style cap which when not in use should be screwed into place, this not only protects the unit from dirt and damage but also adds a stylish finish to your unit and gives you the option to hang it in a pocket securely keeping it in place (Never fill the EGO-W whilst attached to your battery)

 

Using your EGO-W electronic cigarette

 Now you have completed the above you have a fully charged and filled cigarette and you are ready to use it.. The button on the battery is used to fire the unit which will in turn power the EGO-W atomiser and heats up the heating coil which then heats the E-juice to produce the vapour . The power button has a safety feature which enables you to completely turn the battery off so when you are not using the EGO-W e-cig it can’t be accidentally fired. To turn the battery off you simply click the button 5 times in quick succession and repeat to turn it back on. When the battery needs to be recharged the light on the battery of the EGO-W will flash every time you attempt to use it and will not fire so recharge following the above instructions. As you are using the EGO-W occasionally tilt it back and forth to ensure the E- juice is being soaked into the wicking material this will stop you possibly using the unit dry and will stop you possibly burning the wick. When your E-juice level starts to get low and you want to refill always remove the atomiser and tank from the battery and repeat the filling instructions above to avoid accidentally flooding your battery. Always keep external parts and screw threads on both the battery and atomiser clean, dry and free from dirt.


Share this post



← Older Post Newer Post →


Leave a comment

Please note, comments must be approved before they are published.